Wrought iron
Wood & steel frame
Farm & ranch
Sliding driveway gates
LiftMaster operatorsFree on-site gate assessment - hinges, posts, and your LiftMaster or Nice gate operator checked before anything is quoted
The assessment is free and the quote is the invoice.
Get your free estimateFast, Reliable Gate Repair Across Mojave
If your gate won’t open, sags on its hinges, or stopped latching after the last windstorm ripped through the 93501 and 93502 area, you need a technician who knows exactly what Mojave’s high desert does to gate hardware. We service every brand you’re likely to own, from Mighty Mule and Ghost Controls on residential driveway gates to FAAC, BFT, and DoorKing on commercial and ranch systems. Our techs run service calls into Mojave throughout the week, and we’ll walk you through what’s wrong before any work starts. Call (855) 341-7657 for a free estimate.
Why Gate Repair Lancaster Is Mojave’s Preferred Gate Repair Company
Mojave sits in a wind funnel. Air pushes through Tehachapi Pass and rolls across the open Antelope Valley, and every gate in town takes the beating. We’ve worked on gates up and down Sierra Highway, out near the airport, and through the residential streets south of the rail line. We know what happens when caliche-hard soil lets go of a post after one too many 30 mph gusts, and we bring parts and hardware suited to that exact problem.
We’re gate specialists, not generalists. Our Gate Repair team works on gate openers, hinges, posts, and control boards all day, every day. That singular focus means we diagnose faster and carry the dust-proof hinges, reinforced post brackets, and operator components that Mojave’s climate actually demands. Property managers and homeowners across Mojave call us because we speak the language of their specific system, not because we’re the cheapest ad in the phone book.
Our technicians are certified to work on nine major gate brands, including LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule. When you tell us your operator is a FAAC 400 or a Ghost Controls TSS1, we know the board, the limits, and the failure points before we pull into your driveway.
Styles & brands we work with
- Wrought iron
- Wood & steel frame
- Farm & ranch
- Sliding driveway gates
- LiftMaster operators
Sliding Gate Repair in Mojave
Sliding Gate Repair in Mojave usually comes down to one of three things: a post that’s shifted in the wind, a wheel or roller that’s ground itself down in blowing sand, or a limit switch that dust has fouled. A typical service call for sliding gate repair in Mojave runs $185 – $380, depending on whether we’re resetting a post, replacing rollers, or swapping out a control board.
Post Footing and Realignment
Mojave’s caliche soil looks solid but behaves badly under repeated lateral load. Wind pushes a long gate, the gate pushes the post, and the post starts rocking in its footing. That movement throws off the track alignment, and the gate starts binding or refuses to reach the latch. We reset the post, regrade the track line, and add reinforcement brackets where wind load demands it.
Rusted or Worn Rollers and Track
Blowing sand acts like sandpaper on rollers and track wheels. A sliding gate that ground smoothly a year ago starts chattering and sticking because the roller bearings are packed with dust and worn down. We replace worn rollers with sealed units and brush or air-clean the track, then confirm the gate travels its full length without binding.
Wrought Iron Gate Repair in Mojave
Wrought Iron Gate Repair in Mojave tends to involve rust, hinge sag, and wind fatigue on decorative panels. A typical wrought iron gate repair in Mojave runs $165 – $340, depending on whether we’re welding a cracked joint, replacing hinge bolts, or straightening a bowed panel.
Hinge and Post Work
Iron gates are heavy, and Mojave’s gusting wind turns that weight into a prying force on every hinge and weld. We replace sheared hinge bolts, re-drill stripped holes, and realign posts so the gate hangs square and latches clean.
Rust and Weld Repair
The high desert’s temperature swings create condensation that bites into unsealed welds and scratches. We grind back rust, weld reinforcement where panels have cracked, and apply a rust-inhibiting finish so the repair holds through next winter’s freeze-thaw cycle.
Trusted Brands We Service in Mojave
We’re trained and equipped to work on LiftMaster, FAAC, BFT, Linear, Viking, Ghost Controls, DoorKing, Elite, and Mighty Mule systems. That matters in Mojave because a residential Mighty Mule on a chain-link driveway gate fails differently than a commercial FAAC on a business entrance, and we carry parts for both. You won’t wait a week for a board or a limit switch to ship in. We stock the components Mojave’s installers and property owners actually use, which means faster turnaround when your gate is down and security matters. Russ Delano built this company around brand-specific repair knowledge, not guesswork.
See the difference
Before
After
Before
After
Before
AfterCommon Gate Repair Problems We See in Mojave Homes
- Wind-rocked posts in caliche soil. Constant 20-30 mph gusts through Tehachapi Pass push against long chain-link and steel gates until the post starts moving inside its footing. We reset the post, re-anchor it in concrete, and add bracing if the gate surface catches serious wind.
- Sand and dust inside operator housings. Mojave’s blowing dust gets past cheap seals and grinds at limit switches and drive gears. We clean and reseal the housing, then check that the operator’s force and limit settings still match the gate’s travel.
- Solid infill gates bending under wind load. Light steel panels with no wind holes catch every gust and start bowing or cracking at the welds. We straighten bent panels, weld stress cracks, and discuss wind-relief slots or heavier-gauge material where the wind load is worst.
- Frozen or rusted hinges from temperature swings. Sub-freezing winter nights and hot afternoons create condensation that corrodes hinge pins and seizes bearings. We replace rusted hardware with sealed, dust-resistant components and lubricate with a dry film that doesn’t attract sand.
Pricing for Gate Repair in Mojave, CA
Most Mojave gate repairs land between $165 and $380. A simple hinge replacement or latch adjustment starts around $165. Sliding gate track and roller work typically runs $185 – $320. Wrought iron welding and straightening falls between $185 and $340. A full post reset with concrete and re-alignment can reach $380, and operator board or motor replacement generally runs $250 – $450 depending on the brand and model. We quote the price and get your approval before any work starts. No surprises on the invoice. Call (855) 341-7657 and we’ll give you a firm number over the phone or send a tech to the property for a free on-site estimate.
We Also Serve Cities Near Mojave
Our service area covers the Antelope Valley and southern Kern County region, including Rosamond, Lancaster, Desert View Highlands, and Quartz Hill. If your property is a few miles outside Mojave proper, we’ll still run the call. Same team, same brand-specific expertise.
Serving Mojave, CA – Our Local Coverage Area
We’re based in the Mojave area and know this community well. Use the map below to see our service coverage – if you’re nearby, we can almost certainly help.
FAQs About Gate Repair in Mojave
Every automatic gate operator has a manual release mechanism, usually a pull handle or keyed release on the operator housing or a chain release near the motor. Pulling it disconnects the drive so you can push or slide the gate by hand. If you can’t locate it or it’s stiff from dust and rust, call us at (855) 341-7657 and we’ll walk you through it or come out and free it up.
Mojave’s temperature swings create condensation that attacks unprotected steel, and blowing sand accelerates wear on hinge pins and bushings. Standard hardware fails quickly here. We install sealed, dust-resistant hinges with corrosion-resistant coatings and use a dry lubricant that won’t collect sand.
Yes. We excavate around the rocked post, set it back to plumb, re-anchor it in concrete, and often add a reinforced bracket or larger footing if the gate is long and catches heavy wind. The repair typically runs $280 – $380 including materials and labor, and we’ll confirm the exact price before we start digging.
UL 325 is the safety standard that requires automatic gates to have entrapment protection, such as photo eyes, safety edges, or reverse sensors, so the gate can’t crush a person, pet, or vehicle. Yes, your Mojave gate needs it, both for safety and for code compliance. If your operator is missing safety edges or the photo eyes are misaligned from wind vibration, we’ll correct it during the repair call. Call (855) 341-7657 for a free safety check.
The post has almost certainly been rocked out of position. Mojave’s wind pushes the gate hard enough to shift the hinge post or latch post, so the latch no longer lines up with the catch. We realign or reset the post, adjust the latch, and reinforce the footing so the next wind event doesn’t undo the work. That repair usually runs $165 – $280 depending on how far the post has moved.
After a spring wind event in the 93501 ZIP code, our techs responded to a call on a long chain-link driveway gate that wouldn’t latch. The hinge post had been rocked loose from the caliche-hard soil, and the LiftMaster operator’s limit switch was misaligned from the vibration. We reset the post footing with concrete, installed dust-proof hinges, and realigned the operator, restoring smooth operation despite ongoing 25 mph gusts.
If your gate is down, sagging, or refusing to latch after Mojave’s wind, call us at (855) 341-7657. We’ll get it diagnosed, quote the repair, and have you back to secure in one visit.
Written by Russ Delano, Owner at Gate Repair Lancaster, serving Mojave and the Antelope Valley.